Skip to main content

Tape Recovery - Data Recovery

Data Recovery from Tape.

Recovering data from tapes involves first getting an binary image of the tape. We do this using our own software so as to get the best image possible.

Once we have the tape image, we then work out the software that was used to create the backup tape.

Again we have written our own backup recovery software so that we can get the maximum amount of data from the tape.

We are able to recover data from all types of tape including:
AIT,  DAT, DDS, DLT, LTO, QIC, SAIT, SDLT, Travan, Ultrium and most other tape formats.

We are also able to recover from most backup software on all platforms. For more information please check out out our Tape Recovery pages.


Comments

Post a Comment

Please leave a comment on this data recovery blog

Popular posts from this blog

Slow Reponding Toshiba Drives

Toshiba Laptop Data Recovery Some problems have been found with Toshiba Laptop drives where the computer will fail with any of the following symptoms .. The drive hangs during boot Unable to access data Computer is very slow Problem with Drives We found the problem which is related to the G-List ( Grown defect list )it either becomes corrupt or is not readable. If it is not readable by the drive then the correct translator algorithms can not be run and so the drive slows down or even stops completely. Solution to Toshiba Hard Disk Problem. The solution is very complex and requires specialist equipment to enable rebuilding of the defect maps externally to the drive. However, once this is achieved the data can be accessed and a near perfect recovery is possible. For more information on this problem please visit our Toshiba Data Recovery pages.
Post a Comment
Read more

Laptop Data Recovery

A large number of computers sold are laptop computers. They are light and portable. Modern laptops contain very large hard disks at the time of writing this article 500Gb are often seen here for data recovery. One of the most common problems we see are drives where the heads have crashed. The main cause is actually part of the design of the computer - remember the bit where I said 'they are light and portable'? It is easy to put the computer on your lap, then when you need to get up, lift the computer up and put it to one side. This movement can cause a head crash especially if the heads are reading or writing at the time. Most manuals that we have seen recommend putting the computer on a firm surface like a desk or a table and in fact NOT putting it on your lap - strange that they are called 'laptops' when it is not recommended to use them as such. Some manufacturers have developed hardware that detects when the computer is being moved and pulls the heads to a saf...
Post a Comment
Read more